Jaguar Mk II

Saturday 30 May 2015
The Jaguar Mark 2 is a medium-sized saloon car built from late 1959 to 1967 by Jaguar in Coventry, England. Twelve months before the announcement of the XJ6 they were renamed Jaguar 240 and Jaguar 340. The previous Jaguar 2.4 Litre and 3.4 Litre models made between 1955 and 1959 have been identified as Mark 1 Jaguars since Jaguar produced this Mark 2 model.
Until the XJ, Jaguar's postwar saloons were usually denoted by Roman Numerals (e.g. Mark VII, Mark VIII) while the Mark 2 used Arabic Numerals, denoted on the rear of the car as "MK 2".
Adhering to Sir William Lyons' maxim of "grace, pace and space", the Mark 2 was a fast and capable saloon. It came with a 120 bhp (89 kW; 120 PS) 2,483 cubic centimetres (152 cu in), 210 bhp (160 kW; 210 PS) 3,442 cubic centimetres (210 cu in) or 220 bhp (160 kW; 220 PS) 3,781 cubic centimetres (231 cu in) Jaguar XK engine. The 3.8 is similar to the unit used in the 3.8 E-Type (called XKE in the USA), having the same block, crank, connecting rods and pistons but different inlet manifold and carburation (two SUs versus three on the E-Type in Europe) and therefore 30 bhp (22 kW) less. The head of the six-cylinder engine in the Mark 2 had curved ports compared to the straight ports of the E-Type configuration. The 3.4 Litre and 3.8 Litre cars were fitted with twin SU HD6 carburettors and the 2.4 Litre with twin Solex carburettors.
Some explanation is required concerning the claimed bhp figures shown above. Jaguar used gross bhp figures throughout the production period of the Mk II and 240/340 models. A direct conversion into DIN bhp is not possible, but we know that the 3.8 Mk II engine developed around 190bhp DIN.This compares with the later 4.2 XJ6 engine which also gave around 190bhp DIN or 245 gross bhp, according to Jaguar, both being for 8:1 compression engines. The explanation was that the lower peak for the XJ6 4.2 engine meant that the bhp was being delivered at less rpm, for the same output.The camshaft timing and inlet and exhaust valve sizes were the same for the 2.4,3.4,3.8 Mk II and XJ6 4.2 engines, so the engines throttled themselves sooner in the bigger engine sizes. The later 4.2 XJ6 engines had special induction pipes, to reduce exhaust emissions, that crossed over between the inlet and exhaust sides of the engine, which reduced bhp to around 170bhp on later production.
Compared to the Mark 1, appearance of the car was transformed by an increase of 18% in cabin glass area greatly improving vision. The car was re-engineered above the waistline, slender front pillars allowed a wider windscreen and the rear window almost wrapped around to the enlarged side windows now with the familiar Jaguar D-shape above the back door and fully chromed frames for all the side windows. The radiator grille was amended and larger side, tail and fog lamps repositioned. Inside a new heating system was fitted and ducted to the rear compartment (although still notoriously ineffective). There was an improved instrument layout that became standard for all Jaguar cars until the XJ series II of 1973.
The front suspension geometry was rearranged to raise the roll centre and the rear track widened. Four-wheel disc brakes were now standard. Power steering, overdrive or automatic transmissions could be fitted at extra cost. The 3.8 Litre was supplied fitted with a limited-slip differential.
The Mark 2 was over 100kg heavier than the 2.4 / 3.4 cars.
A popular luxury derivative fitted with Daimler's own 142 bhp (106 kW; 144 PS) 2½-litre V8 it sold well from 1962 to 1967 as a Daimler 2.5 V8. In late 1967 it was re-labelled V8-250 to match Jaguar 240. As well as being significantly more powerful than the 2.4-litre XK6 the more modern Daimler engine was lighter by about 150 lb (68 kg) and also shorter which reduced the mass over the front wheels and so reduced understeer during hard cornering.
These cars were recognisable by the characteristic Daimler wavy fluting incorporated in the chrome radiator grille and rear number plate lamp cover, their smoothness and the sound of their V8 engine. They were given distinct exterior and luxury interior fittings.
In September 1967 the 2.4 Litre and 3.4 Litre Mark 2 cars were rebadged as the 240 and 340 respectively. The 3.8 Litre model was discontinued. The 240 and 340 were interim models intended to fill the gap until the introduction of the XJ6 in September 1968. The 340 was discontinued on the introduction of the XJ6 but the 240 continued as a budget priced model until April 1969; its price of £1364 was only £20 more than the first 2.4 in 1956.
Output of the 240 engine was increased from 120 bhp (89 kW; 120 PS) @ 5,750 r.p.m. to 133 bhp (99 kW; 135 PS) @ 5,500 r.p.m. and torque was increased. It now had a straight-port type cylinder head and twin HS6 SU carburettors with a new inlet manifold. The automatic transmission was upgraded to a Borg-Warner 35 dual drive range. Power steering by Marles Varamatic was now available on the 340. Servicing intervals were increased from 2,000 miles to 3,000 miles. There was a slight reshaping of the rear body and slimmer bumpers and over-riders were fitted. For the first time the 2.4 litre model could exceed 100 mph, resulting in a slight sales resurgence.
The economies of the new 240 and 340 models came at a cost – the leather upholstery was replaced by Ambla leather-like material and tufted carpet was used on the floor—though both had been introduced on the Mark 2 a year earlier. Other changes included the replacement of the front fog lamps with circular vents and optional fog lamps for the UK market. The sales price was reduced to compete with the Rover 2000 TC.

Technical data:
- engine: V6
- capacity: 3800 cc
- horsepower: 220 HP
- gearbox: 4+1
- top speed: 201 km/h

1 komentarz:

Władek pisze...

Bardzo dobrej jakości zdjęcia doskonale oddają mocne jak i słabe strony modelu. Sam model bardzo udany i troszkę żałuję że go nie kupiłem kiedy był dostępny w kioskach.

Przy okazji serdecznie zapraszam na mój blog - modele143.blog.pl

Pozdrawiam !